Clobbering

In software engineering and computer science, clobbering a file, processor register or a region of computer memory is the process of overwriting its contents completely, whether intentionally or unintentionally, or to indicate that such an action will likely occur. The Jargon File defines clobbering as

To overwrite, usually unintentionally: "I walked off the end of the array and clobbered the stack." Compare mung, scribble, trash, and smash the stack.

POSIX

Memory or file overwrites in POSIX systems, as well as in shells such as Bash, often happen unintentionally - such as using the > redirection operator. Therefore, to prevent unintentional clobbering, various means can be used - for example, setting the shell parameter set -o noclobber (bash, ksh) or set noclobber (csh, tcsh) will prevent > from clobbering by making it issue an error message instead:

$ echo "Hello, world" >file.txt
$ cat file.txt
Hello, world
$ echo "This will overwrite the first greeting." >file.txt
$ cat file.txt
This will overwrite the first greeting.
$ set -o noclobber
$ echo "Can we overwrite it again?" >file.txt
-bash: file.txt: cannot overwrite existing file
$ echo "But we can use the >| operator to ignore the noclobber." >|file.txt
$ cat file.txt # Successfully overwrote the contents of file.txt using the >| operator
But we can use the >| operator to ignore the noclobber.
$ set +o noclobber # Changes setting back

The default behavior of the mv and cp commands is to clobber their destination file if it already exists. This behavior may be overridden by invoking or aliasing the commands with the -i switch, causing the commands to prompt the user before overwriting the destination file, or -n to not transfer source files with a naming conflict.

Makefiles

In makefiles, a common target clobber means complete cleanup of all unnecessary files and directories produced by previous invocations of the make command. It is a more severe target than clean and is commonly used to uninstall software. Some make-related commands invoke "make clobber" during their execution. They check the CLOBBER environment variable. If it is set to OFF then clobbering is not done.

Assembly

In assembler programming - including inline extended assembly as supported in C and C++ through GCC - the term clobbered registers is often used to denote any registers whose value may be overwritten during the course of executing an instruction or instructions.